Laminar air flow horizontal

• Shore A, 0 and D to measure the hardness of plastics through penetration measurement
• Shore A rubber, elastomers, neoprene, silicone, vinyl, soft plastics, felt, leather and similar material
• Shore 0 foam, sponge
• Shore D plastics, formica, epoxides, plexiglass etc.
• Material thickness of the sample: min. 4 mmDelivered in a hard carrying case
• Particularly recommended for internal comparison measurement. Standard calibrations e. g. to DIN 7619-1 are often not possible because of very narrow standard tolerances
• Can be attached to the test stands TI-ACL (for Shore A and A0), TI-DL (for Shore D) to improve measuring uncertainty
• Large display with backlight
• Selectable: AUTO-OFF function or permanent operation, battery level indicator

Laboratory incubator provides a temperature-controlled environment to support growth of microbiological cultures. Typical incubators are insulated boxes with an adjustable heater, going up to 60°C to 65°C (140°F to 149°F), though some can go slightly higher (generally to no more than 100°C).

Esco Isotherm® laboratory incubator is built with reliable performance and standards. Ergonomic, intuitive interfaces, microprocessor PID controls with programming options, 4-zone heated air jacket, precisely tuned and tested ventilation and insulation package, all supported by Esco’s solutions-based sales and service representatives worldwide.